14
Before you begin
941
* Once the connections have been completed (p. 12, p. 13), turn on power to your various devices in the order specified. By
turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices.
1
Check the following points before you turn on the power.
• Are the connections made correctly?
• Is the power on all connected equipment turned off?
2
On the SH-201’s top panel, turn the MASTER VOL knob all the way to the left.
3
On the SH-201’s rear panel, press the POWER switch to select the “ON” position.
942
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required
before the unit will operate normally.
* Don’t touch the pitch bend lever located at the left of the keyboard while you’re turning on the power.
If you turn on the power while touching the pitch bend lever, the lever may fail to operate correctly.
4
Switch on the power to the connected equipment and raise the volume to an appropriate level.
5
While playing the SH-201’s keyboard, slowly turn the MASTER VOL knob toward the right to an
appropriate volume.
1
Check the following points before you turn off the power.
• Is the volume of the connected equipment turned to the minimum setting?
• Have you saved the sounds you created? (p. 48)
2
Switch off the power on the connected equipment.
3
Press the SH-201’s POWER switch to select the “OFF” position.
Turning the power on/off
Turning the power off
SH-201_r_e.book 14 ページ ２００６年４月２７日 木曜日 午前１１時２８分
To Next Page
Loading...
Need help?
General
