35
Creating sounds
Creating sounds
fig.FILTER-SLOPE-button
This button selects the slope (steepness) of the filter.
Press the button so the indicator for the desired slope is lit.
Each time you press the button you can alternate between the -12 dB and -24 dB setting.
• -12 dB
The filter slope will be gentle, allowing some of the sound near the cutoff frequency to remain.
• -24 dB
The filter slope will be steep, cutting most of the sound immediately above (or below) the cutoff frequency.
fig.FILTER-CUTOFF-knob
This specifies the
cutoff frequency
of the filter.
When the filter TYPE is “LPF”
Turning the knob toward the right brightens the sound, while turning it toward the left darkens (mellows) the
sound.
When the filter TYPE is “HPF”
Turning the knob toward the right will make the sound lighter (less thick), and turning it toward the left will
make the sound heavier (thicker).
When the filter TYPE is “BPF”
Turning the knob toward the right will allow a higher range of frequencies to be heard, and turning it toward the
left will allow a lower range of frequencies to be heard.
* When the filter TYPE is “BYPASS,” turning the knob will not affect the sound.
SLOPE button
CUTOFF knob
frequency
cutoff frequency
-12 dB
Example: LPF (Low Pass Filter) SLOPE settings
level
-24 dB
SH-201_r_e.book 35 ページ ２００６年４月２７日 木曜日 午前１１時２８分
To Next Page
Loading...
Need help?
General
