Roland V-drums User Manual

The World’s Finest Electronic Drums and Percussion. PERIOD.
42
Since the SPD-S is a sample pad, the sounds contained in from the factory are
stored not in ROM (like the SPD-20, HPD-15 & TD-Series drum modules), but are
stored in internal memory that may be deliberately, or inadvertently erased. The
samples (WAV's) and patches must be restored from the data contained on the
CD-ROM that originally shipped with the SPD-S. If you cannot nd this CD-ROM,
please contact Roland customer service for a replacement.
To restore the factory settings, you will need:
CompactFlash Card (32 Mb, minimum, no larger than 512Mb)
Computer (PC or Mac), with CompactFlash card reader and
CD-ROM drive.
SPD-S CD-ROM
(Originally came bundled with the SPD-S owners manual)
SPD-S Pad (to be restored)
Detailed Factory Restore instructions are on page 117-118 of the SPD-S Owners Manual
These instructions will take you through:
• Using the computer to load the CD-ROM & copy the required les onto the
CompactFlash card.
• Loading the data on the CompactFlash card into the SPD-S
Note on "wave protect":
If while trying to restore the factory data, the SPD-S displays reads "wave protect on", you
must rst turn off "wave protect" before you will be able to successfully load the factory data.
To turn off "Wave Protect":
– With the power to the SPD-S off ...
– Hold down the "WAVE" & "SETUP" buttons
– While continuing to hold these buttons down and power up the SPD-S
– Continue to hold these buttons down until the SPD-S display reads "wave protect off"
– Release the buttons, "wave protect" in now "off"
Repeat the Factory Restore power up procedure (#6 on page 117 of the SPD-S Owner's Manual).
Factory Restore of patches and WAV les to the SPD-S
Restoring the SPD-S to Factory Settings

Roland V-drums Specifications

General

Brand	Roland
Model	V-drums
Category	Drums
Language	English