48
Chapter 5. Parameter Guide EFFECTS
SENS (sensitivity) [0–100]
This adjusts the sensitivity at which the filter will change in
the direction determined by the polarity setting. Higher
values will result in a stronger response. With a setting of
“0,” the strength of picking will have no effect.
FREQ (frequency) [0–100]
This adjusts the center frequency of the Wah effect.
PEAK [0–100]
Adjusts the way in which the wah effect applies to the area
around the center frequency. Lower values will produce a
wah effect over a wide area around the center frequency.
Higher values will produce a wah effect in a narrow area
around the center frequency.
* With a value of “50” a standard wah sound will be produced.
RATE [0–100, BPM –BPM ]
Adjusts the frequency of the wah.
* When set to BPM, the value of each parameter will be set
according to the value of the BPM (p. 55) specified for each
patch. This makes it easier to achieve effect sound settings that
match the tempo of the song.
DEPTH [0–100]
Adjusts the depth of the auto wah effect.
LEVEL [0–100]
Adjusts the volume.
Adjusts the tone. Parametric control is provided for the high-
mid range and low-mid range.
ON/OFF
Switches the EQ on/off.
* Turning [VALUE] will select PRESET.
LEVEL [-20–+20 dB]
Adjusts the volume after the equalizer.
LOW G (low gain) [-20–+20 dB]
Adjusts the low frequency range tone.
HIGH G (high gain) [-20–+20 dB]
Adjusts the high frequency range tone.
L-MID G (low-middle gain) [-20–+20 dB]
Adjusts the low-middle frequency range tone.
H-MID G (high-middle gain) [-20–+20 dB]
Adjusts the high-middle frequency range tone.
L-MID F (low-middle frequency)
[100 Hz–10.0 kHz]
Specifies the center of the frequency range that will be
adjusted by the “L-MID G.”
L-MID Q (low-middle Q) [0.5–16]
Adjusts the width of the area affected by the EQ centered at
the “L-MID F.” Higher values will narrow the area.
H-MID F (high-middle frequency)
[100 Hz–10.0 kHz]
Specifies the center of the frequency range that will be
adjusted by the “H-MID G.”
H-MID Q (high-middle Q) [0.5–16]
Adjusts the width of the area affected by the EQ centered at
the “H-MID F.” Higher values will narrow the area.
EQ (equalizer)
To Next Page
Loading...
Need help?
General
