108
Chapter 5 Creating a Performance
Effect Settings
Refer to “Adjusting Effect Settings in Performance mode” (p.
26).
Saving Performances You
Create
Refer to “Saving Performances” (p. 122).
Copying the Settings of
Another Part (Performance
Part Copy)
Part settings from any Performance can be copied to the
currently selected Part. This can save you time when setting
up Parts.
1. Make sure that a Part is selected.
2. Press [UTILITY] to make its indicator light.
3. Press [ ] / [ ] to select the UTIL 1 page.
4. Use [ ] / [ ] to make “COPY” blink, and then
press [ENTER].
The PERFORM PART CPY page will appear.
fig.5-05.e
5. Press [ ] / [ ] to move the cursor to the
parameter that you wish to set.
6. Turn the VALUE dial or press [INC] / [DEC] to select the
desired value.
7. Press [ENTER] to execute the Copy – an asterisk (“*”) is
placed before the copy destination Tone in the display.
fig.5-05a
8. Press [EXIT] to return to the PERFORM PLAY page.
* To specify the currently selected Part as the copy source, set
Source to TEMP.
Copy source Performance
(group, number)
Copy source Part
Copy source Performance
name
Copy destination Part
Performance Name Copy
You can copy the name from a Performance to the
current Performance.
fig.5-05c
1. Select the Performance whose name you wish to
copy.
2. Press [UTILITY] to make its indicator light.
3. Press [u] / [d] to select the UTIL 1 page.
4. Use [l] / [r] to make “COPY” blink, and then press
[ENTER].
5. Press [u] / [d] to select the PATCH NAME CPY
page.
6. Turn the VALUE dial, or press [INC]/[DEC] to select
the copy-source Performance.
7. Press [ENTER] to execute the Copy operation.
Copy source Performance (group, number, name)
To Next Page
Need help?
General
