TROUBLESHOOTING
Problem Possible cause Solution
line will not advance when using the
auto-feed head:
Line is welded to itself. Lubricate with silicone spray.
Not enough line on spool.
Install more line. Refer to Line replacement earlier in
this manual.
Line is worn too short. Pull line while pressing button.
Line is tangled on spool. Remove line from spool and rewind. Refer to Line
Replacement earlier in this manual.
Grass wraps around boom
housing and cutting head
Cutting tall grass at ground level. Cut tall grass from the top down to prevent wrapping.
Motor fails to start when switch
trigger is depressed.
Battery is not secure. To secure the battery pack, make sure the latches on
each side of the battery pack snap into place.
Battery is not charged.
Charge the battery pack according to the instructions
included with your model.
To Next Page
Loading...
Need help?
General