all moving parts have come to a complete stop before:
● servicing
● leaving the product unattended
● cleaning your product
● changing accessories
● clearing blockages
● checking for any damage after hitting an object
● checking for any damage if the product starts to
vibrate abnormally
● performing maintenance
WARNING
Inspection after dropping or other impacts: Thoroughly
inspect the product and identify any problems or
damage to it. Any part that is damaged should be
properly repaired or replaced by an authorised service
centre.
TRIMMER SAFETY WARNINGS
■ Replace string head if cracked, chipped, or damaged
in any way. Be sure the string head is properly
installed and securely fastened. Failure to do so can
cause serious injury.
■ Avoid using on wet grass.
■ Do not walk backwards when using the product.
■ Walk, never run.
■ The small blade fitted to the cutting attachment guard
is designed to trim the new extended line to the correct
length, for a safe and optimum performance. It is very
sharp; do not touch it, particularly when cleaning the
product.
■ Always ensure that ventilation openings are kept clear
of debris.
■ Before each use and after any impact, check that there
are no damaged parts. Examine the cutting means
for signs of cracking or other damage. A defective
switch or any part that is damaged should be properly
repaired or replace by an authorised service facility.
■ Make sure the head attachment is properly installed
and securely fastened.
■ Make sure all guards, deflectors, and handles are
properly and securely attached.
■ Do not modify the product in any way, this may
increase the risk of injury to yourself or others.
■ Use only the manufacturer's replacement line in the
cutting head. Do not use any other cutting attachment.
■ Never operate the product without the cutting
attachment guard in place and in good condition.
■ Maintain a firm grip on both handles while trimming.
Keep the string head below waist level. Never cut with
the string head located over 76 cm above the ground.
RESIDUAL RISKS
Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise in use and
the operator should pay special attention to avoid the
following:
■ Injury caused by vibration. Always use the right tool for
the job, use designated handles and restrict working
time and exposure. See the section “Risk Reduction”
in this manual.
■ Hearing injury caused by exposure to noise. Wear
hearing protection and limit exposure.
■ Eye injury due to flying debris. Wear eye protection
at all times.
■ Injury caused by falling objects. Wear head protection
if there is any risk of falling objects.
RISK REDUCTION
It has been reported that vibrations from handheld tools
may contribute to a condition called Raynaud’s Syndrome
in certain individuals. Symptoms may include tingling,
numbness, and blanching of the ngers, usually apparent
upon exposure to cold. Hereditary factors, exposure to
cold and dampness, diet, smoking, and work practices
are all thought to contribute to the development of these
symptoms. It is presently unknown what, if any, vibrations
or extent of exposure may contribute to the condition.
There are measures that can be taken by the operator to
possibly reduce the effects of vibration:
■ Keep your body warm in cold weather. When operating
the product, wear gloves to keep the hands and wrists
warm. It is reported that cold weather is a major factor
contributing to Raynaud’s Syndrome.
■ After each period of operation, exercise to increase
blood circulation.
■ Ensure that the product is correctly located in a
designated working position before starting.
■ Limit the amount of exposure per day. Take frequent
work breaks.
If you experience any of the symptoms of this condition,
immediately discontinue use and see your doctor.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
