2
ENGLISH
SPECIFIC SAFETY RULES
n For best results, your battery tool should be charged in a location where the temperature is more than 10°C but less than 38°C.
To reduce the risk of serious personal injury, do not store outside or in vehicles.
n Under extreme usage or temperature conditions, battery leakage may occur. If liquid comes in contact with your skin, wash immediately
with soap and water, then neutralise with lemon juice or vinegar. If liquid gets into your eyes, flush them with clean water for at least 10
minutes, and seek immediate medical attention. Following this rule will reduce the risk of serious personal injury.
SYMBOLS
SYMBOL NAME EXPLANATION
V Volts Voltage
A Amperes Current
Hz Hertz Frequency (cycles per second)
W Watt Power
min Minutes Time
~
Alternating Current Type of current
Direct Current Type or a characteristic of current
n
o
No Load Speed Rotational speed, at no load
Class II Tool Double-insulated construction
.../min Per Minute Revolutions, strokes, surface speed, orbits etc., per minute
Wet Conditions Alert Do not expose to rain or use in damp locations.
Safety Alert Precautions that involve your safety.
Read the Operator’s Manual To reduce the risk of injury, user must read and understand
operator’s manual before using this product.
Wear Eye and Hearing Protection Wear eye protection which is marked to comply with ANSI Z87.1
as well as hearing protection when operating this equipment.
Keep Bystanders Away Keep all bystanders at least 50 ft. away.
Ricochet Thrown objects can ricochet and result in personal injury or
property damage.
No Blade Do not install or use any type of blade on a product displaying
this symbol.
Petrol and Lubricant Use unleaded petrol intended for motor vehicle use with
an octane rating of 87 [(R + M) / 2] or higher. This product is
powered by a 2-stroke engine and requires pre-mixing petrol
and 2-stroke lubricant.
Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of these
symbols will allow you to operate the product better and safer.