• This equipment meets the pollution degree.
• Inappropriate or the harmonized installation environment may jeopardize the life span of the inverter.
• Installation directly exposed under intensive sunlight is not recommended.
• The installation site must be well ventilated.
3.1. Determining the Installation Position
3.1.1. Installation Environment Requirements
⚫ The installation environment must be free of inflammable or explosive materials.
⚫ The device must be installed in a place away from heat source.
⚫ Do not install the device at a place where the temperature changes extremely.
⚫ Keep the device away from children.
⚫ Do not install the device at daily working or living arears, including but not limited to the following areas:
bedroom, lounge, living room, study, toilet, bathroom, theater and attic.
⚫ When installing the device at the garage, please keep it away from drive way.
⚫ Keep the device from water sources such as taps, sewer pipes and sprinklers to prevent water seepage.
⚫ The product is to be installed in a high traffic area where the fault is likely to be seen.
NOTE: When installing outdoors, the height of the device from the ground should be considered to
prevent the device from soaking in water. The specific height is determined by the site environment.
3.1.2. Installation Location Requirements
⚫ The equipment employs natural convection cooling, and it can be installed indoor or outdoor.
⚫ Do not expose the inverter to direct solar irradiation as this could cause power derating due to
overheating.
⚫ Install the eManager-C1 Pro vertically or backwards with the maximum angle of 15 degrees. Do not tilt
it forwards, sideways, horizontally, or upside down.
To Next Page
Loading...
Need help?
General
