7.1 Reviewing Setpoint Temperature via device
Press once or to review Setpoint temperature. The flame icon won’t be turned on.
When operating in Frost protection mode, the LCD will show frost setpoint with the Frost Protection
indicator displayed.
Press Backlight or wait 2 seconds without key press to return to normal operation, room temperature will be
displayed.
Actual room temperature Setpoint temperature
By changing the Setpoint temperature, you are permanently altering your temperature. You can change the
set point temperature very easily while you are reviewing the set point temperature. Press the UP or DOWN
keys repeatedly to change the temperature setting. The set point temperature will flash to indicate that it can
be changed: the temperature will be changed in 0.5°C steps per key press.
The RT310i will return to Normal mode if no keys are pressed for more than 2 seconds. Once the new Setpoint
has been implemented, the change is permanently overridden until a new Setpoint is set again. Setpoint
temperature cannot be changed if Frost Protection mode is enabled.
7.2 Adjusting setpoint via device
7. Operating in Oine Mode
If the Internet connection is lost and the thermostat is not communicating with the App or with the gateway,
it can still be operable in offline mode. When in offline mode:
• The thermostat will follow the last set schedule
• Setpoint can be changed and reviewed via device
TESTING/PAIRINGTESTING/PAIRING
TESTING/PAIRING
TESTING/PAIRING
TESTING/PAIRINGTESTING/PAIRING
Actual room temperature Setpoint temperature 2 seconds timeout Actual room temperature
RT310i Installation Manual 25
To Next Page
Loading...
Need help?
General
