INSTALLATION
Please read the important safety information at the start of this manual
before you begin to install the device.
The RT500 programmable room thermostat is easily installed using the
Industry Standard back plate supplied with the unit – this is used purely for
mounting purposes, as no wiring is needed for the RT500. The back plate
can be mounted directly to the wall surface.
The ideal position to locate the RT500 is about 1.5m above floor level. It
should be mounted in a location where the thermostat is accessible,
reasonably lit and free from extremes of temperature and draughts. Do not
mount the thermostat on an outside wall, above a radiator or in a location
where it may be subjected to direct sunlight.
To ensure trouble free operation of the Radio Frequency (RF) signal, always
ensure that the programmable thermostat is mounted away from any
possible sources of interference (such as radios, TV sets, computers, etc.),
and is not mounted on or in close proximity to large metal objects. Installing
the RT500 in enclosed areas such as cellars and basements is not
recommended.
CONNECTING THE RT500 BOILER CONTROL
NOTE: All electrical installation work should be carried out by a
suitably qualified electrician or other competent person.
If you are not sure how to install the Boiler Control consult either with a
qualified electrician, heating engineer or your boiler / heating system
supplier for advice on how to continue.
RT500BC INSTRUCTION MANUAL
4
Salus RT500BC Boiler Control 026_89 21/01/2012 18:18 Page 4
To Next Page
Loading...
Need help?
General
