NETWORK PTZ CAMERA User Guide
62
Chapter 4. Using Web Viewer
To save a desired location for the Pan/Tilt or Zoom/Focus operation along with detailed
camera settings for the location, configure the following options.
Category Description
Number Select a number to identify a preset. (Preset numbers 1 to 255 are available.)
Name Name a preset.
Move Moves to a selected preset when its number is selected.
Edit Enables detailed camera settings to be configured for a preset.
Add
Saves a preset; move to a desired location for the Pan/Tilt or Zoom/Focus operation, enter
a preset number and name, and then press the Add button to save the location as a
preset.
Delete Deletes an existing preset; select a preset number, and then press the Delete button.
t/FXTFUUJOHTBSFTBWFEPOMZJGZPVDMJDLUIF button on the right of the screen.
To configure detailed camera settings for a preset, select a preset number, and then move the
camera to the preset before pressing the
button.
ÿPreset Setup
ÿSequence Setup
Category Description
Swing Commands the camera to move between 2 selected presets, monitoring the route.
Group
Recalls groups of multiple preset locations consecutively. A group can contain up to
255 presets.
Tour
Recalls groups of presets consecutively in an orderly manner. Up to 6 groups can be
listed for this function.
Trace & Auto Run
Trace saves and reactivates patterns of custom camera movements. Up to 4
movement patterns can be memorized.
Auto Run commands the camera to automatically perform a preset sequence action if
no command has been entered via the controller for a while.
You can configure detailed sequence settings for each camera mode. Available camera
modes are Swing, Group, Tour, Trace, and Auto Run, and they are described in the chart
below.
Caution
To Next Page
Loading...
Need help?
General
