English
Chapter Two: Installation
Connecting Your Monitor
to a Computer
1
2
3
4
Turn off your computer and unplug
its power cord.
Connect the signal cable to the
signal port on the back of your
monitor.
If you are using a Macintosh com-
puter, connect the other end of the
signal cable to a Macintosh
adapter. (The adapter is not includ-
ed with your monitor. Contact your
dealer for more information.) If you
are using an IBM-compatible com-
puter, skip to step 5.
Follow the instructions included
with your adapter to set the pins
on your adapter, if necessary.
5
6
7
8
Connect the signal cable (with the
adapter if necessary) to the video
port on the back of your computer.
This port might be directly
attached to your computer, or it
might be part of a video board,
video card, or graphics card.
Connect the power cord for your
monitor to the power port on the
back of the monitor.
Plug the power cords of your com-
puter and your monitor into a near-
by outlet.
Turn on your computer and mon-
itor. If your monitor displays an
image, installation is complete.
5
To Next Page
Loading...
Need help?
General