Sanyo CES26WSD7-B User Manual

English -15-
Main Menu
Channel List
Installation
Configuration
Timers
Language
TV Setup
Common Interface
Detailed information about Sound, Picture and Fea-
ture menus are in AnalogueTV Menu System section
on page 19.
Common Interface
• Press the "M" button to display the Main Menu and
use the or button to highlightthe “Common Inter-
face” line and press the“SELECT” button.
Main Menu
Channel List
Installation
Configuration
Timers
Language
TV Setup
Common Interface
It is required to subscribe to a pay channel company
toview the paychannelsof theDigitalTerrestrial broad-
casting.
Obtain the ConditionalAccess Module (CAM) and the
Viewingcardbysubscribingtoa pay channelcompany,
then insert those to the Television using the following
procedure.
1. Switch off the TV and unplug from the mains.
2. Insert theCAM, then Viewing Card to the slot that is
located in the terminal cover at the left-hand side of
the TV (from front view).
• TheCAM shouldbecorrectlyinserted, itisimpossible
to insert fully if reversed. The CAM or the TV terminal
maybedamaged if theCAM is forcefullyinserted.
3. Connect the TV to the mains supply, switch
on and then wait for few moments until the
card is activated.
• SomeCAMs may requirethefollowing set up. Please
set the CAM by entering the IDTV menu, Common
Interface then pressing the “SELECT” button. (CAM
set up menu is not displayed when it is not required.)
• To see the viewing contract information:
EnterIDTV; press the"M" button, then highlight Com-
mon Interface and press the “SELECT” button.
• When no module is inserted, “No Common Inter-
face module detected” message appears on the
screen.
• Refer to the module instruction manual for details of
the settings.
Analogue TV Menu System
Picture Menu
PICTURE
Mode
Contrast
Brightness
Sharpness
Colour
In picture menu if PC,YPbPr or HDMI modes are
selected, resolution information is displayed at the
bottom of the menu osd.
Mode
By pressing

/

button, select Mode. Press

/

button to choose from one of these options: Cinema,
Dynamic and Natural.
Contrast/Brightness/Sharpness/Colour/Hue
By pressing

/

button, select the desired Option.
Press

/

button to set the level.
Hint: Hue is displayed in picture menu when the TV
receives an NTSC signal.
Colour Temp
• By pressing

/

button select Colour Temp.
• Press

/

to choose from one of these options:
Cool, Normal and Warm.
ENG-32781W-1050UK-32 INCH 17MB22 UK IDTV-(2 HDMI-WO PIP-SPDIF)-50104961.p65 04.04.2007, 16:5915

Sanyo CES26WSD7-B Specifications

General

Brand	Sanyo
Model	CES26WSD7-B
Category	TV
Language	English