4 Use your TV
Switching on your TV and putting it in
Standby mode
To Turn the TV On from Standby or Off to Standby
●
Press B on the Side panel or the Remote Control.
Note(s)
●
Energy Consumption contributes to air and water pollution. When the AC Power Cord is
plugged in, your TV consumes energy with a very low Standby Power Consumption.
Adjusting Volume
To decrease or increase Volume
●
Press VOL J / K on the Side panel or press VOL + / – on the Remote
Control.
VOL J (–) : Volume Down
VOL K (+) : Volume Up
To mute or unmute sound
●
Press D on the Remote Control to Mute the sound.
●
Press D again on the Remote Control or VOL + / – to recover the
original sound.
Switching Channels
To Select Channels by using CH H / I or CH + / –
●
Press CH H (Up) / I (Down) on the side panel or press CH + / – on the
Remote Control.
To Select Channels by using the NUMBER buttons
●
For Digital channels, press a number followed by a dot “•” and the
corresponding sub channel number.
–
When selecting Digital channel 11.1
Be sure to press • before entering the subchannel number.
Cable / NTSC (Analog) TV Operation
–
When selecting Cable or Analog channel 11
Press PREV.CH to return to the previously viewed channel.
Note(s)
●
To Select the non-memorized channels, use the NUMBER buttons.
●
Channel not available or No signal will appear on the TV screen after the subchannel
broadcast is over.
●
Audio only message will appear on the TV screen, when you receive only sound signal.
19 .English
Continued on next page.
To Next Page
Loading...
Need help?
General
