Sanyo KHS1822 User Manual

Operation with the Remote
Control Unit
STEP 1
STEP 2
STEP 5
STEP 3
STEP 4
1. Cooling
Check that the circuit breaker on the power panel is turned on and the
operation selector of the indoor unit is in the ON position.
STEP 1: Set the MODE selector switch to COOL.
STEP 2: Set the timer selector switch to NORM.
STEP 3: Press the ON/OFF operation button.
STEP 4: Press the COOLER or WARMER button to set a cooler or
warmer temperature.
Each time you press these buttons, the set temperature
varies by 2°F.
84'’F max.
64°F min.
STEP 5: Set the fan speed selector switch to the setting you want.
To stop the air conditioner, press the ON/OFF operation button again.
• Choose the best position in the room for the remote control unit,
which also acts as the sensor for room comfort and transmits the
operating instructions. Once you've found this best position, always
keep the remote control unit there.
• This appliance has a built-in 3-minute time delay circuit to ensure
reliable operation, if the operation button is pressed, the compressor
will start running after three minutes. In the event of power failure,
the unit will stop. When the power is applied, the unit will re-start
automatically after 3 minutes.
• To prevent the appliance from malfunctioning, do not set any
selector switch between two indicated positions. Make sure that it
clicks into position.
07 - 346-09
9

Sanyo KHS1822 Specifications

General

Brand	Sanyo
Model	KHS1822
Category	Heat Pump
Language	English