Sanyo KHS1822 User Manual

How to Install Batteries
Slide to open
Using the Remote Control Unit
1. Press and slide the lid on the back of the remote control unit in the
direction of the arrow.
2. Install two AAA alkaline batteries. Make sure the batteries point in
the direction marked in the battery compartment.
3. Press the ACL button, then replace the lid. If you press it, the current
time, ON time, and OFF time are all reset to 12:00. This may make it
easier for you to reset those times. (See "Setting the Timer".)
• The batteries last about six months, depending on how much you
use the remote control unit. Replace the batteries when the remote
control unit's lamp fails to light, or when the remote control cannot
be used to change the air conditioner's settings.
• Use two fresh leak-proof type-AAA alkaline batteries.
• In replacing batteries, follow the instructions as mentioned in the
sub-section "How to Install Batteries".
• If you do not use the remote control unit more than 1 month, take
out the batteries.
How to Use the Remote
Control Unit
When using the remote control unit, always point the unit's transmitter
head directly at the air conditioner's receiver.
Remote Control Unit
Installation Position
Remote
cradle
The indoor remote unit may be operated either from a non-fixed
position or from a wall-mounted position. To ensure that the air
conditioner operates correctly, do not install the remote control unit in
the following places:
• In direct sunlight
• Behind a curtain or other places where it is covered
• More than 26 ft. away from the air conditioner
• In the path of the air conditioner's airstream
• Where it may become extremely hot or cold
• Where it may be subject to electrical or magnetic noise
1. If Non-fixed Position
Raise the rear plate of the remote control unit mounting cradle and
insert the remote control unit. The unit can be used either in that
position (placed on a table, for instance) or held in the hand.
2. If Wall-mounted Fixed Position
Install the remote control unit at a convenient location on a nearby wall.
However, before attaching the remote control unit mounting cradle,
check that the remote control unit can operate from the desired wall
position.
8
07 - 346-08

Sanyo KHS1822 Specifications

General

Brand	Sanyo
Model	KHS1822
Category	Heat Pump
Language	English