22
RECORDING
Recording copyright material without permission
of the copyright owners is usually an infringement.
If you wish to re-record copyright material,
permission from the copyright owner is necessary.
SANYO does not approve of, and cannot be held
responsible for, any unlawful use of this unit.
Recording from USB Memory
device (Synchronous recording)
1. Load a blank cassette.
2. Select the USB function.
3. Connect a USB memory device.
- Select the file number if required.
- For programmed recording, pro-
gramme the material in advance.
4. Press the REC button. The PLAY button
is engaged simultaneously and recording
starts.
5. Press the STOP/EJECT button to stop
recording at any time. When the end of the
tape is reached, the cassette deck stops
automatically and the playback of USB memory
device enters pause mode.
Recording compact discs
(Synchronous recording)
1. Load a blank cassette.
2. Select “CD” function.
3. Load the disc to be recorded.
- Select the track number if required.
- For programmed recording, programme
the material in advance (as described
under “PROGRAMMED PLAY”).
4. Press the REC button. The PLAY button is
engaged simultaneously and CD recording
starts.
5. Press the STOP/EJECT button to stop
recording. When the end of the tape is reached,
the cassette deck stops automatically and the
playback of CD enters pause mode.
Recording from the radio
1. Load a blank cassette.
2. Tune in the radio station to be recorded.
3. Press the REC button to start recording.
4. Press the STOP/EJECT button to stop
recording.
When beat is heard
Beat (a high-pitched noise) may sometimes be
heard during the recording of radio broadcasts.
If this occurs, set the BEAT CANCEL switch (the
back of the unit) to 1 or 2 position that reduces
the level of the beat noise.
Safeguards against accidental
erasure
To protect side A, break out tab (1). To protect
side B, break out tab (2) (Fig.10).
- To erase or record a protected cassette, cover
the tab openings with adhesive tape (3).
Note:
The REC button cannot be depressed when using
a protected cassette.
MAINTENANCE
Cleaning the tape heads
To ensure continued high performance, use a
cleaning tape (available from your local audio
dealer) to clean the head block of the deck after
about every 10 hours of use.
Cleaning the CD player lens
The lens should never be touched. If dust is on
the lens, blow it off using a camera lens blower.
(Consult your dealer.) (Fig.11)
Cleaning the unit
Clean the outside of the unit with a clean soft
cloth, moistened with lukewarm water. Do not
use benzene, thinners, or alcohol. Because they
may mar the finish of the surfaces.
To Next Page
Loading...
Need help?
CD Player
Radio
