19
Connect the projector's AC power cord into an AC
outlet. The POWER indicator becomes red.
Press the POWER ON-OFF button on the remote
control. The POWER indicator becomes green and the
cooling fans start to operate. The preparation display
appears on the screen and the count down starts.
2
3
1
16
The preparation display disappears after 30
seconds.
4
After the countdown, the input source that was
selected last and the Lamp mode status icon (see p.
46) appear on the screen.
If the projector is locked with a PIN code, PIN code
Input Dialog Box appear. Enter the PIN code as
instructed below.
(See p. 46 for Lamp mode)
Selected Input Source and Lamp Mode
Complete peripheral connections (with a computer,
VCR, etc.) before turning on the projector.
Lamp mode
Pointer
After the OK icon
disappears, you can
operate the projector.
PIN Code Input Dialog Box
Tu r ning On the Projector
Basic Operation
Enter a PIN code
Installation
Select a number by pressing the Point 7 8 buttons and fix
the number with the SELECT button. The number changes
to "✳". If you fixed an incorrect number, move the pointer
to "Set" or "Clear" once by pressing the Point d button, then
return to "PIN code". Enter the correct number again.
Repeat this step to complete entering a four-digit number.
"1234" is set as the initial PIN code at the factory.
When the four-digit number is fixed, the pointer is
automatically move to "Set". Press the SELECT button so
that you can start to operate the projector.
If you entered an incorrect PIN code, "PIN code" and the
number (✳✳✳✳) turn red and disappear. Enter the correct
PIN code all over again.
What is PIN code?
PIN code is a security code using Personal Identification
Number that allows the person who knows it to operate the
projector. Setting PIN code prevents others except the
specific users from operating the projector.
A PIN code consists of a four-digit number. Refer to PIN
code lock function in Setting on pp. 47, 48 for locking
operation of the projector with your PIN code.
✔
Note:
• When the Logo select function is "Off", the logo
is not shown on the screen. (p. 43)
• When the "Countdown off" or "Off" is selected in
the Display function, the countdown is not shown
on the screen. (p. 42)
• During the countdown period, all operations are
invalid.
• If the correct PIN code number is not entered for
3 minutes after the PIN code dialog box
appeared, the projector is turned off
automatically.
CAUTION ON HANDLING PIN CODE
If you forget your PIN code, the projector can no
longer be started. Set a new PIN code with special
care, take a memo and keep it at hand. Should the
PIN code be missing or forgotten, consult your
dealer or service center.
To Next Page
Loading...
Need help?
General
