20
Basic Operation
Press the POWER ON-OFF button on the remote
control, and "Power off?" appears on the screen.
Press the POWER ON-OFF button again to turn off the
projector. The POWER indicator starts to blink red, and
the cooling fans keep operating. (You can select the
level of fan quietness and rotation speed. See p. 49.)
At this time you can disconnect the AC power cord
even if the fans are still running.
1
2
TO MAINTAIN THE LIFE OF THE LAMP, ONCE
YOU TURN THE PROJECTOR ON, WAIT AT
LEAST 5 MINUTES BEFORE TURNING IT OFF.
3
When the projector has cooled down enough to be
turned on again, the POWER indicator becomes red.
The message disappears after 4 seconds.
✔
Note:
• When the On start function is "On", this projector is turned on
automatically by connecting the AC power cord to an AC outlet.
(p. 46)
• Do not operate the projector continuously without rest. Continuous
use may result in shortening the lamp life. Turn off the projector
and give it a rest about an hour in every 24 hours.
• The running speed of cooling fans is changed according to the
temperature inside the projector.
• Do not put the projector in a case before the projector is cooled
enough.
• If the WARNING indicator blinks or emits a red light, see "Warning
Indicator" on p. 53.
• While the POWER indicator is blinking, lamp is being cooled down
and the projector cannot be turned on. Wait until the POWER
indicator becomes red to be turned on again.
Tu r ning Off the Projector
To Next Page
Loading...
Need help?
General
