18
The preparation display will disappear after 30
seconds.
(See page 54 for Lamp control status.)
7XUQLQJ2QWKH3URMHFWRU
Connect the projector’s AC power cord into
an AC outlet. The POWER indicator lights
red. Open the lens cap.
Press the ON/STAND-BY button on the
top control or on the remote control.
The POWER indicator lights green and
the cooling fans start to operate. The
preparation display appears on the screen
and the countdown starts.
Complete peripheral connections (with a
computer, VCR, etc.) before turning on the
projector.
6HOHFWHG,QSXW6RXUFHDQG/DPSFRQWURO
3Note
The Filter warning and Lamp replacement
icons may appear on the screen depending
on the usage state of the projector.
Basic Operation
4
After the countdown, the input source that
was selected the last time and the Lamp
control status icon (p.54) appear on the
screen.
31RWH
:KHQ WKH /RJRVHOHFW IXQFWLRQ LV VHW WR 2II, the
logo will not be shown on the screen (p.46).
:KHQ &RXQWGRZQ RII or 2II is selected in the
Display function, the preparation display will not
be shown on the screen (p.46).
:KHQWKH,QSXWVHDUFKIXQFWLRQLVVHWWROn 2, the
input signal will be searched automatically (p.45).
:KHQ 2II is selected in the Display function, the
Video/PC selection window and the input signal
guidance window are not shown on the screen
(p.46).
5
If there is no signal input when start on the
projector, or the current signal is missed
while operating the projector, the Video/
PC selection window will be displayed
on the screen, please move the pointer
to input source desired by pressing the
3RLQWŸźEXWWRQVDQGSUHVVWKH6(/(&7
button. And then follow the input signal
guidance window to correct the signal and
connection.
If the projector is locked with a PIN code,
PIN code input dialog box will appear. Enter
the PIN code as instructed on the next
page.
Video Selection
*XLGDQFHIRU9LGHR,QSXW
PC Selection
*XLGDQFHIRU3&,QSXW
Lamp control status
1
2
3
16
To Next Page
Loading...
Need help?
General
