Sanyo XHS2432 User Manual

4. Service procedures
1
2
3
4
Section
– 61 –
SM830076
(5) Symptoms and parts to inspect
1) Symptom: LCD on the remote controller does not display and remote controller does not
operate.
No
No
No
No
No
No
NoNo
No
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Start
Replace the
indoor unit PCB.
Is there 12 V DC
between 2 and 3
of the remote
controller?
Replace the
remote controller.
Repair the
remote
controller
wiring.
Has the indoor
unit PCB fuse blown?
Check and repair the
power breaker etc.
Replace the indoor unit’s
power transformer.
Is the 230-208 V AC
circuit shorted?
Replace or repair.
Replace the
indoor unit PCB.
Is there 230-208 V AC
between R and S of
the indoor PCB?
Is the LED (D80) on
the indoor unit PCB lit?
Is there 12 V DC
between R2 and R3
on the 8P terminal
plate of the indoor unit?
Is the primary
side of the indoor
power transformer
shorted?
Is there 230-208 V AC
between U1 and U2
of the 8P terminal
plate?
Are the connections
for the 4P connector
for the indoor unit’s
PCB power trans-
former good?
Is there 15 V AC
between 1 and 2
of the 4P connector
for the indoor unit’s
power transformer?
Miswiring of
power supply
wires and
indoor/outdoor
control lines
Correct the
connections
Replace the
indoor unit power
transformer.
Correct the
wiring. Remove the
socket connected to
the OC plug on the
PCB and connect to
the EMG plug instead.
1144_THS_I

Sanyo XHS2432 Specifications

General

Brand	Sanyo
Model	XHS2432
Category	Air Conditioner
Language	English