THE PRESENT MANUAL BELONGS TO - Schenker Italia - ALL RIGHTS RESERVED
12
Hydraulic Connection
Water inlet: ¾’’ fitting, 16mm internal diameter rinforced hose.
Water outlet: ¾’’ fitting, 16mm internal diameter rinforced hose.
Feed pump type: Shurflo diaphragm pump
Filters: n. 1 Cartridge filter 5 microns 2.32" x 9 ¾’’
n. 1 Active carbon filter 2.32" x 9 ¾’’
Power supply: 12 VDC +/- 15% (60M12 version)
. 24 VDC +/- 15% (60M24 version)
Average electric consumption: 250 Watt/h average
Peak electric consumption: 400 Watt
Nominal fresh water production: 60 Lit/h +/- 20% @ seawater 25 °C salinity 35.000 ppm
Fresh water quality: Under 500 ppm TDS average
CEE conformity: In compliance with directives 89/392 CEE sect.1 (general safety machines
requirements), 89/336 CEE (electromagnetic compatibility), 73/23 CEE
(electric safety requirements)
3.6 Characteristic of the product
The machine uses sea water to produce fresh water.
The water produced by the Schenker plant, starting from clean sea water, is potentially drinkable. The requisite
of potable water cannot be guaranteed, however, because in some parts of the system there may be a bacterial
charge, especially in the event of non-observance of the cleaning and storage procedures. Therefore, it is
suggested to avoid drinking the fresh water produced by the plant, if a UV sterilizer is not installed.
ATTENTION
Do not drink fresh water produced by the watermaker if a UV sterilizer system is not installed.
To Next Page
Loading...
Need help?
General
