www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
52
|
GB
Storing a chain saw
Storing a chain saw for longer than 30 days requires
storage maintenance. Unless the storage instruc-
tions are followed, fuel remaining in the carburetor
will evaporate, leaving gum-like deposits. This could
lead to dicult starting and result in costly repairs.
• Remove the fuel tank cap slowly to release any
pressure in tank. Carefully drain the fuel tank.
• Start the engine and let it run until the unit stops
to remove fuel from carburetor.
• Allow the engine to cool (approx. 5 minutes).
• Remove the spark plug.
• Pour 1 teaspoon of clean 2-cycle oil into the com-
bustion chamber. Pull starter rope slowly several
times to coat internal components. Replace spark
plug.
m NOTE
Store the unit in a dry place and away from possible
sources of ignition such as a furnace, gas hot water
heater, gas dryer, etc.
General Chain saw
Saw chain
Chain brake
Guide bar
Clean exterior, check for damage. In case of damage have
repaired by a qualied service center immediately
Sharpen regulary, replace in good time
Have inspected regularly at an authorized service center
Turn over to ensure even wear of bearing surfaces
Replace in good time
Before each start Saw chain
Guide bar
Chain lubrication
Chain brake
OFF switch, Safety locking
button, Throttle lever
Fuel/ oil tank cup
Inspect for damage and sharpness
Check chain tension
Check for damage
Functional check
Functional check
Functional check
Check for tightness and leckage
Every day Air lter
Guide bar
Guide bar support
Idle speed
Clean
Check for damage, clean oil intake bore
Clean, in particular the oil guide groove
Check (chain must not run)
Every week Fan housing
Cylinder space
Spark plug
Muer
Spark arrester screen
Chain catch sleeve
Screws and nuts
Clean to ensure proper air cooling
Clean
Check and replace if necessary
Check tightness of mounting
Clean
Check for damage, replace if necessary.
Check their condition and that they are rmly secured.
Every 3 months Fuel lter
Fuel, oil tank
Replace
Clean
Storage Chain saw
Guide bar/ chain
Fuel, oil tank
Carburretor
Clean exterior, check for damage. In case of damage, have
repaired by a qualied service center immediately
Demount, clean and oil slightly
Clean the guide groove of the guide bar
Empty and clean
Run empty
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: Saw chain, Guide bar, Saw chain oil, En-
gine oil, Spiked bumper, Chain catcher, Spark plug,
air lter, fuel lter, saw chain oil lter
* Not necessarily included in the scope of delivery!
11. Storage
m CAUTION
Never put a chain saw into storage for longer than 30
days without carrying out the following steps.
Follow the cleaning instructions and maintenance in-
structions before storing the device.
To Next Page
Loading...
Need help?
General
