www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
42
|
GB
17. Troubleshooting
Fault Possible causes Action
Blade dissolves after
switching o the
engine
To slightly tightened fastening nut Tighten the right hand thread nut
Engine will not start Failure mains fuse Check mains fuse
Defective extension cable Replace extension cord
Connections on motor or switch not in
order
Repair by electrical specialist
Motor or switch faulty Repair by electrical specialist
Motor will not work,
the fuse is active
Cross section of the extension cable is not
sucient
See „Electrical connection“
Overload by a blunt saw blade Change saw blade
Fire marks on the
cutting surface
Blunt saw blade Have saw blade sharpened (only by an
authorised sharpening specialist) or change it
Wrong saw blade Change saw blade
To Next Page
Loading...
