www.scheppach.com
GB
|
31
18. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault Possible cause Remedy
Motor does not work Engine, cable or connector defective,
fuses burnt.
Have the machine checked by a specialist.
Never repair the engine yourself.
Danger! Check the fuses and replace them if
necessary.
The engine runs slowly
and does not reach the
operating speed.
Voltage too low, coils damaged,
capacitor burnt.
Have the voltage checked by a utility provider.
Have the engine checked by a specialist.
Have the capacitor replaced by a specialist.
Motor makes excessive
noise
Coils damaged, motor defective Have the engine checked by a specialist.
The motor does not
reach its full power.
Circuits in the network are overloaded
(lamps, other motors, etc.)
Do not use any other equipment or engines on
the same circuit.
Motor overheats easily. Overloading of the motor, insucient
cooling of the motor
Avoid overloading the engine while cutting.
Remove dust from the engine in order to
ensure optimal cooling of the engine.
Saw cut is rough or
wavy.
Saw band dull, tooth shape not appro-
priate for the material thickness
Sharpen the saw band or insert a suitable saw
band.
Workpiece pulls away
and/or splinters.
Excessive cutting pressure and/or
saw band not suitable for use.
Insert a suitable saw band.
Burn marks on the
wood when working.
Saw band blunt.
Incorrect speed.
Replace the saw band.
Choose a suitable speed for the workpiece to
be cut.
Saw band jams when
working.
Saw band blunt.
Saw band resinous.
Replace the saw band.
Clean the saw band.
To Next Page
Loading...
Need help?
General
