www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
27
Setting the cutting height
m CAUTION!
Adjust the cutting height only when the engine is
switched o and the plug boot has been pulled.
•
blade is not blunt and that none of the fasteners are
damaged.
•
pull the spark plug boot.
• -
-
ent cutting heights can be selected.
•
cutting height. The lever snaps into the desired po-
sition. (Fig. 13)
Preparing the area to be mowed
8. Operation
m CAUTION!
The engine does not come with oil in it. There-
fore, ensure that you add 0,45 liters of oil before
starting it up. Use normal, multigrade oil (SAE30).
The oil level in the engine must be checked each
time before mowing.
You will also need to ll in petrol, as this is also
not supplied upon delivery.
•
lawn mower, it comes equipped with an engine
brake (Fig. 1/ Item 3) which must be pulled back
before the engine can be started. When the engine
control lever is released it must return to its initial
• Press the engine brake lever (3) together and give
the starter cord (17) a vigorous pull. (Fig. 14)
-
ting blade rotates even when dissolved motor brake
danger zone of cutting blade.
•
this operation several times in order to ensure that
m WARNING
Whenever you need to perform any kind of ad-
justment and/or repair work on your lawn mower,
wait until the blade has come to a complete stop.
Always switch o the engine before carrying out
any adjustments, maintenance or repairs.
•
• Low outside temperatures
• Extended periods of use
and take regular breaks.
7. Before rst use
Assembling the components
Some parts of the mower come disassembled. For
-
tions below.
Important! You will need the following additional tools
work:
•
• -
erating hours)
•
• Household wipes (to wipe up oil/petrol residue; dis-
• A petrol suction pump (plastic, available from DIY
stores)
• An oil can with hand pump (available from DIY
stores)
• 0,35 liter of engine oil (SAE 30)
Assembly
1. Take the mower and attachment parts out of the
packaging and check that all parts are present.
2. Attach the lower push bar to both sides of the
mower with one screw (a), 1 washer (c), 1 plastic
star grip nut (d) each. Make sure that the cables,
(Fig. 2-3).
3. Attach the upper push bar on the lower push bar
with one quick-release lever (5), one washer big
(b), one washer small (c) and one plastic star grip
nut (d) each on both sides (Fig. 4-5). Note the cor-
slice ensuring the quick-release function remains
intact.
4. Insert the pull start handle (17) in the designated
hook as shown in Fig. 6.
5. Fix the cables to the push bar with the cable clips
(18) provided (Fig. 7).
6. Grass box (16) - open it up and click the plastic
clips into position on the frame (Fig. 8).
7. Mowing with grass box:
hang the grass box (16) as shown in Fig. 9.
8. Mulching:
If the grass box (16) is attached, remove it and
replace it with the mulch insert (19) as shown in
Fig. 10-12.
To Next Page
Loading...
Need help?
General
