www.scheppach.com
28
|
GB
Single-phase motor
• The mains voltage must coincide with the voltage
specied on the motor’s rating plate.
• Extension cables up to a length of 25 m must have
a cross-section of 1.5 mm
2
, and beyond 25 m at
least 2.5 mm
2
.
• The connection to the mains must be protected with
a 16 A slow-acting fuse.
Only a qualied electrician is permitted to connect the
machine and complete repairs on its electrical equip-
ment.
In the event of enquiries please specify the following
data:
• Motor manufacturer
• Type of current of the motor
• Data recorded on the machine’s rating plate
• Data recorded on the switch’s rating plate
11. Maintenance
If specialist personnel must be brought in for ex-
traordinary ser vice or repairs during the warran-
ty period and thereafter, please contact a service
provider recommended by us or con tact the man-
ufacturer directly.
• Overhauls, maintenance work, cleaning, as well as
the eli mi nation of any malfunctions must only be
undertaken af ter turning o the motor.
• All protective and safety equipment must be rein-
stalled immediately upon completion of any repair
or maintenance work.
Regular maintenance
The regular maintenance described above and in the
para graph below can be carried out by unskilled per-
sonnel.
• Do not oil the plunge cut saw, cause cutting must
be carried out in dry conditions; all rotating parts
are self-lubricating.
• During maintenance, wear protective gear if possi-
ble (accident-prevention goggles and gloves).
• Remove cuttings when necessary both from the cut-
ting area, work surfaces and support bases.
Use of an aspirator or brush is recommended.
ATTENTION: Do not use compressed air jets!
Regularly check blade conditions: if diculties should
arise during cutting, have it sharpened by skilled per-
sonnel or replace it if necessary.
Sawing with dust suction
Connect the suction hose to the exhaust nozzle - Ø
38 mm (12).
Splitter protection (g. 1b)
The splinter protection (15) improved signicantly at
0° cuts are the quality of the cut edge of the sawed-o
workpiece part on the upward side.
• Place the machine on the workpiece and guide rail.
• Splitter guard (15) down until it rests on the work-
piece and tighten the knob.
• Splitter guard (15) sawing. At the rst use of split-
ter guard (15) we sawed this to generate an exact
stop area.
10. Electrical connection
The installed electric motor is completely wired
ready for operation.
The customer’s connection to the power supply
system, and any extension cables that may be
used, must conform with local regulations.
Important remark:
The motor is automatically switched o in the event of
an overload. The motor can be switched on again after
a cool ing down period that can vary.
Defective electrical connection cables
Electrical connection cables often suer insulation
dam age. Possible causes are:
• Pinch points when connection cables are run
through window or door gaps.
• Kinks resulting from incorrect attachment or laying
of the connection cable.
• Cuts resulting from running over the connecting
cable.
• Insulation damage resulting from forcefully pulling
out of the wall socket.
• Cracks through aging of insulation.
Such defective electrical connection cables must not
be used as the insulation damage makes them ex-
tremely hazardous.
Check electrical connection cables regularly for dam-
age. Make sure the cable is disconnected from the
mains when checking.
Electrical connection cables must comply with the reg-
ulations applicable in your country.
To Next Page
Loading...
Need help?
General
