12
English
FACTORY DEFAULT RESET
When should you perform a Factory Default Reset?
• If you want to move the lock to a different door, you need to restore default settings, move
the lock to the new door, and then set up the lock again.
• If you have forgotten your Programming Code, you can restore the default codes.
WARNING
Locate the default Programming and User Codes on the back of this guide or the back
of the Alarm Assembly before beginning! Default Programming and User Codes will be
restored. All existing User Codes and current Programming Code will be erased.
CUSTOMER SERVICE CANNOT RETRIEVE LOST DEFAULT CODES! DO NOT
RESTORE FACTORY SETTINGS UNLESS YOU CAN LOCATE THE DEFAULT CODES.
1. Disconnect the batteries. See Replacing the
Batteries on page 4.
2. Press and hold the Outside Schlage Button.
3. While holding the Outside Schlage Button,
reconnect the batteries.
4. Release the Outside Schlage Button.
L If you are moving the lock to a new door, install
the lock on that door before continuing.
5. To check that the lock was reset, press the Outside
Schlage Button and enter one of the Default User
Codes. See Default Codes Locations on page
10.
6. If the reset was successful, the lock will perform a setup routine. Wait until the bolt stops
moving. The reset and setup are complete.
EMERGENCY KEY OVERRIDE
Emergency Key Override can be used when the battery is
completely dead, or when no valid User Code is known.
Insert key and rotate to unlock, just like any lock. See
Replacing the Batteries on page 4.
This lock may be rekeyed to match other locks in a
residence. Contact a locksmith for assistance.
To Next Page
Loading...
Need help?
General
