13
English
Z-WAVE
This lock is equipped with a Z-Wave® radio.
L The Z-Wave radio is disabled by default to conserve battery life. When the lock is enrolled
for the rst time, the radio is automatically enabled.
About Z-Wave
This lock is a Security Enabled Z-Wave Product.
• This lock may be included into any Z-Wave network to enable remote control of the lock,
from any manufacturer or service provider.
• Listening nodes from any manufacturer or service provider can act as repeaters to extend
network range.
• The lock will have limited functionality if included with a non-secure controller.
• Replication is the process of copying the network data from a primary controller to a
secondary controller on the network. For more information, please see your controller’s
documentation.
• This device supports Anti-Theft. Enabling Anti-Theft protection requires an Anti-Theft
enabled controller. For more information, please see your controller’s website or
documentation.
Enrolling on a Z-Wave Network
This lock may be included into any Z-Wave network, from any manufacturer.
STOP
Refer to your home automation system’s documentation or website for more
information, then continue.
Enroll your lock:
Extend the bolt on the lock and then perform the following:
Enroll/Unenroll
the Lock
6 Digit
Programming
Code
OR
The lock was
Enrolled/
Unenrolled
The lock was
not Enrolled/
Unenrolled
To verify enrollment:
1. Remove the battery cover. See Replacing the Batteries on page 4.
2. Disconnect the battery connector.
3. While watching the inside Schlage button, reconnect the battery connector.
4. The inside Schlage button will blink if the lock is enrolled.
PROGRAMMING USING Z-WAVE
Many home automation systems support features of the deadbolt including locking,
unlocking, and various other programming options.
Refer to your home automation system documentation
or website for more information.
To Next Page
Loading...
Need help?
General
