Page 74 of 106 Basic Rider Optimization Training for the Segway HT
Instructor Guide and Participant Workbook Rev 3.5i - January 2004
© Segway LLC 2002 P/N 1707100001aa
Required Tools
You will need the following tools:
> Hex wrenches, sizes 2.5, 3, 4 and 5MM
> Torque wrench with parameters where 50 Newton Meters (N-m) falls near the middle of the range
> 16MM deep socket
> T-15 or T-20 six lobed wrench (depending on Segway HT vintage)
> Flathead screwdriver
> Air pressure gauge
> Tire pump
> Plastic or rubber mallet
> Alcohol wipes
> Tweezers
HT Fastener Guidelines
1. Use only Segway-provided fasteners.
2. Do not reuse any fastener except for the screws used to attach the Battery Packs, Control Shaft
clamp bolt, and wheel nuts. Instead, when any other fastener is removed, replace the fastener
with a new Segway-provided fastener.
3. Before using a fastener, make certain the fastener is the correct size and type.
4. Do not attempt to repair any stripped or damaged screw hole. Instead, replace the part.
5. Insert fasteners slowly and carefully. Do not cross-thread or over-tighten fasteners. Tighten only
to the prescribed torque. If a fastener is cross-threaded, call Segway Customer Operations at 1-
866-4SEGWAY.
To Next Page
Loading...
Need help?
General