Basic Rider Optimization Training for the Segway HT Page 85 of 106
Instructor Guide and Participant Workbook Rev 3.5i - January 2004
© Segway LLC 2002 P/N 1707100001aa
Installing an Upper Frame and Bag Cargo Structure
Tools Required: 2.5mm and 4mm hex wrenches, torque wrench
Before you begin:
> Make sure Segway HT is shut down and
not plugged into an AC outlet.
> Do not use the parking stand to support
the Segway HT while performing this
procedure. The parking stand is not
designed to withstand the forces that may
be generated. Instead, position the
Segway HT so that you have easy access
to the front of the Handlebar and Control
Shaft.
Directions:
1. If present, remove the two button head
screws located on the bottom of the
handlebar using a 4mm hex wrench.
2. Align the holes in the wire frame with the
screw locations in the bottom of the
handlebar so that the frame is on the
front side of the control shaft.
3. Install the two button head screws
through the holes in the wire frame and
into the bottom of the handlebar using a
4mm hex wrench and torque to 7.5 N-m.
4. Install the clamp on the control shaft just
above the height adjustment collar with the
hook facing forward and up.
5. Note: Replace any fasteners you remove
when performing this installation with the
new fasteners included in the kit.
6. Slide the clamp up to the wire frame so that
the wire frame rests in the hook.
7. Install the clamp screw and with a 2.5mm
hex wrench torque to 1.5 N-m. (The gap
between the halves of the clamp should be
about 4mm.)
8. Lightly tap the wire frame so that it snaps in
the hook of the clamp.
9. Drape the cargo bag over the handlebar so
that the Display and Key Port are not
obstructed.
10. Secure the hook and loop straps around
the wire frame at the bottom and sides of
the bag.
To Next Page
Loading...
Need help?
General