ENGLISH
sharkclean.eu59
60
WARNING: Hand wash
filters only with water
to prevent damage from
cleaning chemicals.
Allow ALL filters to air-
dry completely before
replacing them in the
vacuum to prevent liquid
from being drawn into
electricparts.
CAUTION: Turn off
power and remove
power pack before
servicing.
IMPORTANT: Clean the
dust screen inside the dust
cup as required.
NOTE: Empty dust cup when
debris reaches the MAX fill
line.
MAINTAINING YOUR VACUUM
EMPTYING THE DUST CUP
1 To empty dust cup, first remove the handheld vacuum from
the wand by pressing the Wand Release button and pulling
up on the handheld vacuum. Position dust cup over a bin,
then open the bottom of the dust cup by pressing the Dust
Cup release button on the side.
RECOMMENDED
FILTER CLEANING
SCHEDULE:
Pre-Motor Filter Kit
(Foam & Felt)
Clean once a month.
CLEANING THE FILTERS
1 To clean the foam filter, remove the filter cover lid on the top of the handheld vacuum and
slide off the foam filter. Rinse foam filter and filter frame with water. Tap loose dirt off filter
between washes as needed. Once foam filter is completely dry, return it to the filter frame,
then replace the filter frame and the filter cover.
2 To clean the felt filter, remove the cover on the bottom of the handheld vacuum by pressing
the release button. Remove felt filter. Rinse with water. Once completely dry, reinsert the felt
filter and close the filter cover lid.
FELT FILTER
FOAM FILTER FILTER FRAME
FILTER COVER LID
To Next Page
Loading...
Need help?
General
