CD-C1W,CP-C1W
– 16 –
SW202 SPAN SELECTOR 50/9
SW701 VOLUME UP/DOWN OFF
SW702 JOG DIAL OFF
SW702A PICKUP IN OFF
SW703 X-BASS OFF
SW704 EQUALIZER/DEMO OFF
SW705 SRS MODE OFF
SW706 SRS PASS OFF
SW707 FF OFF
SW708 STOP OFF
SW709 EDIT NORMAL OFF
SW710 EDIT HIGH OFF
SW711 RECORD/PAUSE OFF
SW712 FORWARD PLAY OFF
SW713 DOLBY-NR OFF
SW717 REWIND OFF
SW718 CD PAUSE OFF
SW719 REVERSE PLAY OFF
SW720 REVERSE MODE OFF
SW721 CLOCK OFF
SW722 TIMER OFF
SW723 SLEEP OFF
SW724 VIDEO/AUX OFF
SW725 TAPE 1/2 OFF
SW726 TUNER (BAND) OFF
SW727 CD OFF
SW732 CLEAR OFF
SW733 MEMORY/SET OFF
SW734 POWER ON/STAND-BY OFF
SW739 DISC 3 OPEN/CLOSE OFF
SW740 DISC 3 OFF
SW741 DISC 2 OPEN/CLOSE OFF
SW742 DISC 2 OFF
SW743 DISC 1 OPEN/CLOSE OFF
SW744 DISC 1 OFF
SW851 VOLTAGE SELECTOR 230V-240V
SWB101,102
CAM1, 2 OFF
SWB103,104
CAM3, 4 OFF
SWB105 CD EJECT OFF
SWB107 CD IN OFF
SWB108 CD SET OFF
SWE1 TAPE 2 SIDE A FP OFF
SWE2 TAPE 2 PLAY OFF
SWE3 TAPE 2 SIDE B FP OFF
SWE4 TAPE 2 CrO
2
OFF
SWE7 TAPE 1 CrO
2
OFF
SWE9 TAPE 1 PLAY OFF
NOTES ON SCHEMATIC DIAGRAM
• Resistor:
To differentiate the units of resistors, such symbol as K and
M are used: the symbol K means 1000 ohm and the symbol
M means 1000 kohm and the resistor without any symbol is
ohm-type resistor. Besides, the one with “Fusible” is a fuse
type.
• Capacitor:
To indicate the unit of capacitor, a symbol P is used: this
symbol P means micro-micro-farad and the unit of the
capacitor without such a symbol is microfarad. As to electro-
lytic capacitor, the expression “capacitance/withstand volt-
age” is used.
(CH), (TH), (RH), (UJ): Temperature compensation
(ML): Mylar type
(P.P.): Polypropylene type
• Schematic diagram and Wiring Side of P.W.Board for this
model are subject to change for improvement without prior
notice.
Figure 16 TYPES OF TRANSISTOR AND LED
• The indicated voltage in each section is the one measured by
Digital Multimeter between such a section and the chassis
with no signal given.
1. In the tuner section,
( ) indicates AM
< > indicates FM stereo
2. In the main section, a tape is being played back.
3. In the deck section, a tape is being played back.
( ) indicates the record state.
4. In the power section, a tape is being played back.
5. In the CD section, the CD is stopped.
• Parts marked with “ ” ( ) are important for
maintaining the safety of the set. Be sure to replace these
parts with specified ones for maintaining the safety and
performance of the set.
POSITIONREF. NO DESCRIPTION
REF. NO DESCRIPTION POSITION
FRONT VIEW
2SD2012
2SK2541
KTA1504 Y
KTC3875 GR
2SB1375
KV1236Z23
KDV147 C
SPR325MV
333GTH2
333GTH4
(3)(2)(1)
(D)(G)(S)
B C E
VIEW
FRONT
TOP
VIEW
E C B
VIEW
FRONT
2SC535 C
2SC1845
2SC2236 Y
2SC2878 B
2SC2878 A
2SD468 C
KTA1266 GR
KTA1270 Y
KTA1271 Y
KTA1273 Y
KTC3199 GR
KTC3200 GR
KTC3203 Y
KRA107 M
KRC102 M
KRC104 M
KRC107 M
VIEW
FRONT
E C B
(S)(G)(D)
(1)(2)(3)
1
3
2
484GT44
VIEW
FRONT
VIEW
FRONT
To Next Page
Loading...
Need help?
General
