Use this mode when the remote control is not available.
1
Press the POWER button on the unit.
• The red OPERATION lamp on the unit will
light.
• If the unit has not been unplugged since it
was last operated, it will resume operation at
its last settings.
• If the unit has been unplugged since it was
last operated, it will resume operation in the
cooling mode, set at 68°F. The fan speed set
to AUTO.
ITO TURN OFF !
Press the POWER button again.
• The red OPERATION lamp on the unit will turn
off.
Prepare for drainage and drain out water within the unit in the following cases.
• When the unit stops operating and the TIMER, OPERATION and MEGA COOL lamps are
blinking, the water tank is full and need to be drained.
• When the unit is not used for a long time.
Unplug the power plug and move the unit to a
drain or outside.
Remove the stopcock from the drainpipe, and
drain water within the unit.
Replace the stopcock to the drainpipe.
)cock
Drainpipe
E-30
To Next Page
Loading...
Need help?
General
