To Next Page

To Previous Page

Be sure to disconnect the power from the wall socket before performing any mainte=

nance,

If the filter is clogged with dust, the airflow will be reduced, resulting in poor cooling

performance. The filter should be cleaned every two weeks.

AIR FILTER

Grille --

Air inlet filter

REMOVE THE FILTER

• Gently pull the filter handle to the right and

slide the filter out of the unit.

CLEAN THE FILTER

• Use a vacuum cleaner to remove any dust. If

the filter is very dirty, wash it with detergent

and rinse carefully with clean water. Dry the

filter in the shade before reinstalling them.

REINSTALL THE FILTER

• Hold the filter handle and gently push the filter

back into place.

Never operate the unit without the filter. Doing

so may result in serious damage to the unit.

AIR INLET FILTER JFor sinqle=duct t_vp_e_L

Remove the grille and clean the air inlet filter

with a vacuum cleaner.

CLEANING THE UNIT AND THE REMOTE CONTROL

Wipe them with a soft, dry cloth or with a cloth moistened with a mild soap. Carefully remove

any residue by wiping with a damp cloth and dry completely.

Avoid splashing water onto the unit. Water can dangerously damage the electrical insulation.

Never use harsh chemicals or abrasive cleaners on any part of the unit. To avoid damaging

the unit, do not use hot water (120°F/50°C or hotter) when cleaning.

MAINTENANCE AFTER AIR CONDm0NER SEASON

Perform drainage to drain out water within the unit.

Operate the unit in the FAN or VENTILATION mode for about half a day to

thoroughly dry inside the unit.

Clean the filters, then reinstall them.

E=31

Sharp CV-PD13PX User Manual

Other manuals for Sharp CV-PD13PX