40
Connecting a PC
Selecting the input resolution
• Some input signals may have to be registered manually to
display properly.
• The input signals (resolutions) in the list below are not
distinguishable when received. In such case, you have to
set the correct signal manually. After setting once, it will
display when the same signal (resolution) is input again.
NOTE
• You can only select the “Input Signal” on the Setup menu
when receiving one of the 5 input signals listed above.
Press MENU and the MENU screen displays.
1
Press c/d to select “Setup”.
2
Input resolution settings
Press
a
/
b
to select “PC Setup”, and then
press ENTER.
3
Press
a
/
b
to select the desired input signal
on the display, and then press ENTER.
5
1024 x 768
1280 x 768
1360 x 768
Press
a
/
b
to select “Input Signal”, and then
press ENTER.
4
(Example)
640 x 480 / 60 Hz
848 x 480 / 60 Hz
1024 x 768 / 60 Hz
1280 x 768 / 60 Hz
1360 x 768 / 60 Hz
19A33X_en_f.indd 4019A33X_en_f.indd 40 2007/07/25 14:39:392007/07/25 14:39:39
To Next Page
Loading...
Need help?
General