5
Preparation
1
2
1
Insert the stand into the openings on the bottom of the TV.
2
Insert and tighten the 3 screws into the 3 holes on the rear of the stand.
Hex key
Screw
Soft cushion
NOTE
• To detach the stand, perform the steps in reverse order.
Confi rm the 3 screws supplied with the TV.
• Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being
damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
Screws (
g
3)
(used in step 2)
Attaching the stand
CAUTION
• Adjust the screen with both hands. Put one hand on
the TV and tilt the screen while steadying the stand
with your other hand.
To change the vertical angle of the TV, tilt the screen up to
2.5 degrees forward or 10 degrees backward.
19A33X_en_b.indd 519A33X_en_b.indd 5 2007/07/23 18:22:012007/07/23 18:22:01
To Next Page
Loading...
Need help?
General