12
°
35°
Part Names of Main Unit
Controls
Note:
• TV/VIDEO, CH (
)/(
)
(–)/(+) (Volume) and MENU on the main unit have the same functions as the same buttons on the remote
control. Fundamentally, this operation manual provides a description based on operation using the remote control.
Headphone jack
Plug the headphone mini-plug into the Headphone jack located on
the front of the TV set.
OPC sensor
Remote sensor
OPC sensor indicator (Optical Picture Control)
The Optical Picture Control indicator lights up green when the
Brightness is set to Auto.
POWER/STANDBY/Remote sensor indicator
A green indicator lights when the power is on and a red indicator
lights when in the standby mode (the indicator will not light when the
main power is off). A red indicator blinks when the TV set receives
the remote control signal.
(–)/(+) (Volume)
Upper control panel
CH (
)/( )
MENU
TV/VIDEO
(MAIN POWER)
The screen can be adjusted
backwards to an angle between
12 degrees and 35 degrees.
The screen cannot be set up
straight. When changing the
angle, make sure to hold the
stand and adjust the screen to
the best viewable angle.
Speaker
Adjustable range
Terminals
POWER INPUT DC 12V
Antenna
AV-IN 1
(21-pin Euro-SCART)
AUDIO OUT (R)
AUDIO OUT (L)
Rear View
Carrying handle
AUDIO (R)
AUDIO (L)
VIDEO
S-VIDEO
AV-IN2
● The screen can be adjusted back-
wards to an angle between 12 and 35
degrees.
When changing the angle, make sure
to hold the stand and adjust to the
best viewable angle.
* Be careful to prevent the product from
falling over when adjusting the angle.
Also place the product on a stable
base.
Stand
Round lock for Kensington
Security Standard Slot.
To Next Page
Loading...
Need help?
General