Sharp LC-42D64U User Manual (English)

To Next Page

To Previous Page

LC-42/46/52D64U

5 – 4

3. Entering and exiting the adjustment process mode

1) Before entering the adjustment process mode, the AV position RESET in the video adjustment menu.

2) While holding down the “VOL (–)” and “INPUT” keys at a time, plug in the AC cord of the main unit to turn on the power.

The letter “<K>” appears on the screen.

3) Next, hold down the “VOL (–)” and “CH ( )” keys at a time.

(The “VOL (–)” and “CH ( )” keys should be pressed and held until the display appears.)

Multiple lines of blue characters appearing on the display indicate that the unit is now in the adjustment process mode.

When you fail to enter the adjustment process mode (the display is the same as normal startup), retry the procedure.

4) To exit the adjustment process mode after the adjustment is done, unplug the AC cord from the outlet to make a forced shutdown. (When the

power was turned off with the remote controller, once unplug the AC cord and plug it again. In this case, wait 10 seconds or so before plugging.)

CAUTION: Use due care in handling the information described here lest your users should know how to enter the adjustment process mode. If the

settings are tampered in this mode, unrecoverable system damage may result.

4. Remote controller key operation and description of display in adjustment process mode

1) Key operation

*Input mode is switched automatically when relevant adjustment is started so far as the necessary input signal is available.

2) Description of display

Remote controller key Main unit key Function

CH ( / ) CH ( / )

Moving an item (line) by one (UP/DOWN)

VOL (+/–) VOL (+/–) Changing a selected item setting (+1/ –1)

Cursor (UP/DOWN) ————— Turing a page (PREVIOUS/NEXT)

Cursor (LEFT/RIGHT) ————— Changing a selected line setting (+10/ –10)

INPUT ————— Input switching (toggle switching)

(TUNER→INPUT1→INPUT2→INPUT3→INPUT4→INPUT5→INPUT6→INPUT7)

ENTER ————— Executing a function

(3) Current selected input

(2) Current page title

(4) Current color system

(1) Current page/ (5) Destination

(6) LCD Panel size/Speaker type

Total pages

1/32 [INFO] INPUT5 AUTO USA 46_UNDER

MAIN Version 0.95 ( U 2006/02/02 1)

BOOT Version D64U 1.01

Monitor Version 0.88

Monitor BOOT Version 1.00

EQ DATA CHECKSUM ROM

(8) Parameters

TEMPERATURE 7B

LAMP ERROR 0

MONITOR ERR CAUSE 0

NORMAL

STANDBY CAUSE 0

ERROR STANDBY CAUSE 1) 0 2) 0 3) 0

00H 00M 00H 00M 00H 00M

4) 0 5) 0

00H 00M 00H 00M

(7) Adjustment

process menu

header

(LC-46D64U: 46_UNDER)

(LC-42D64U: 42_UNDER)

(LC-52D64U: 52_UNDER)

Need help?

Do you have a question about the Sharp LC-42D64U and is the answer not in the manual?

Sharp LC-42D64U Specifications

General

Screen Size	42 inches
Display Type	LCD
Backlight Type	CCFL
Brightness	450 cd/m²
Response Time	6 ms
HDMI Ports	2
Component Video Inputs	1
Composite Video Inputs	1
Audio Output	10W x 2
Aspect Ratio	16:9
Refresh Rate	60 Hz
Resolution	1920 x 1080
Inputs	HDMI, Component, Composite
Sound Output	10W x 2