EasyManuals Logo
Home>Sharp>Microwave Oven>R-15AM

Sharp R-15AM Service Manual

Sharp R-15AM
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
R-15AM
9
TROUBLESHOOTING GUIDE
When troubleshooting the microwave oven, it is helpful to follow the Sequence of Operation in performing the checks.
Many of the possible causes of trouble will require that a specific test be performed. These tests are given a procedure
letter which will be found in the “Test Procedure” section.
IMPORTANT: If the oven becomes inoperative because of a blown fuse F1 (F10A) in the 1st. interlock switch SW1 -
monitor switch SW3 - relay RY-2 circuit, check the 1st. interlock switch SW1, monitor switch SW3 and
relay RY-2 before replacing the fuse F1 (F10A).
TEST PROCEDURE
CONDITION PROBLEM
POSSIBLE CASE
AND
DEFECTIVE PARTS
Home fuse or circuit
breaker blows when power
cord is plugged into wall
outlet.
Fuse F1 F10A blows when
power cord is plugged into
wall receptacle.
88:88 does not appear
in display when power
cord is first plugged into
wall outlet.
Oven lamp does not light
when door is opened.
Oven lamp lights but fan
motor and antenna motor
do not operate.
Oven does not go into
cook cycle when START
button is touched.
Oven seems to be
operating but little or no
heat is produced in oven
load. (Food incompletely
cooked or not cooked at
all at end of cook cycle.)
Oven goes into a cook
cycle but extremely uneven
heating is produced in oven
load (food).
Oven does not cook
properly when programmed
for Cooking 50% power
mode. (Operates properly
on Cooking 100% power
mode.)
"EE9" Maximum time is
exceeded.
OFF
CONDITION
COOKING
CONDITION
ERROR MODE
MAGNETRON
HIGH VOLTAGE TRANSFORMER
H.V. RECTIFIER ASSEMBLY
HIGH VOLTAGE CAPACITOR
THERMAL CUT-OUT
1ST. INTERLOCK SWITCH
FUSE F1 F10A
HIGH VOLTAGE FUSE
NOISE FILTER
TOUCH CONTROL PANEL
KEY UNIT
EXCEED MAX. HEATING TIME
RELAY (RY3)
RELAY (RY2)
RELAY (RY1)
FOIL PATTERN ON P.W.B.
LOW VOLTAGE
WRONG OPERATION
DIRTY OVEN CAVITY
MISADJUSTMENT SWITCH
SHORTED IN POWER CORD
OVEN LAMP OR SOCKET
COOLING FAN MOTOR
ANTENNA MOTOR
SHORT OR OPENED WIRING
MONITOR SWITCH
2ND. INTERLOCK RELAY CONTROL SWITCH
ABC DE E EF GH I I
J
K L M M M N CK RE RE RE CK CK CK CK

Other manuals for Sharp R-15AM

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sharp R-15AM and is the answer not in the manual?

Sharp R-15AM Specifications

General IconGeneral
BrandSharp
ModelR-15AM
CategoryMicrowave Oven
LanguageEnglish

Related product manuals