Plug power supply cord into a standard 3-pronged
14 Amp, 120V AC 60Hz power outlet.
After placing the food in a suitable container, open
the oven door and put it on the glass tray.
The glass tray and roller guide must always be in
place during cooking.
Close the door. Make sure that it is rmly closed.
The oven light is on when the microwave oven is
operating.
The oven door can be opened at any time during
operation by pushing the door open button of
control panel. The oven will automatically shut off.
Each time a pad is touched, a BEEP will sound to
acknowledge the touch.
The oven automatically cooks on full power
unless set to a lower power level.
The display will show “ ” when the oven is
plugged in.
Time clock returns to the present time when the
cooking time ends.
When the STOP/CLEAR pad is touched during the
oven operation, the oven stops cooking and all
information retained. To erase all information(except
the present time), touch the STOP/CLEAR pad
If the START/+30 SEC pad is touched and the oven
Make sure the oven is properly installed and
plugged into the electrical outlet.
WATTAGE OUTPUT CHART
O P E R A T I O N P R O C E D U R E
This section includes useful information about oven operation.
P O W E R L E v E L ( D I S P L A Y )
A P P R O x I M A T E P E R C E N T A G E O F P O W E R
PL10 100%
PL9 90%
PL8 80%
PL7 70%
PL6 60%
PL5 50%
PL4 40%
PL3 30%
PL2 20%
PL1 10%
PL0 0%
oven operation, all information is retained.
once more. If the oven door is opened during the
0:00
does not operate, check the area between the door
and door seal for obstructions and make sure the
door is closed securely. The oven will not start cooking
until the door is completely closed or the program
has been reset.
•
The power level is set by setting a cooking time, then selecting Power Level, then press number keys to
choose the power level needed. The chart shows the display, the power level and the percentage of power.
T O U C H T H E N U M B E R P A D
1
0
2
3
4
5
6
7
8
9
10
To Next Page
Loading...
Need help?
General
