EasyManuals Logo
Home>Shure>Receiver>PG2

Shure PG2 User Manual

Shure PG2
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
9
Specifications
System
Working Range 75m (250 ft.) Note: actual range depends on RF signal absorption, reflection,
and interference.
Audio Frequency Response Minimum: 45 Hz.
Maximum: 15 kHz (overall system frequency depends on microphone element).
Total Harmonic Distortion
0.5%, typical
Ref. +/– 33 kHz deviation, 1 kHz tone
Dynamic Range >100 dB A-weighted
Operating Temperature
Range
–18°C (0°F) to +57°C (+135°F) Note: battery characteristics may limit this
range
Transmitter Audio Polarity
Positive pressure on microphone diaphragm (or positive voltage to tip of
WA302 phone plug) produces positive voltage on pin 2 (with respect to pin 3 of
low impedance output) and the tip of the high impedance 1/4-inch output.
PG1 Bodypack
Transmitter
Audio Input Level –10 dBV maximum at “mic” gain position
+10 dBV maximum at 0dB gain position
+20 dBV maximum at –10dB gain position
Gain Adjustment Range
30 dB
Input Impedance 1MΩ
RF Transmitter Output
10 mW typical
Dimensions 110 mm H x 64 mm W x 21 mm D (4.3 x 2.5 x 0.8 in.)
Weight
75 grams (2.6 oz.) without battery
Housing Molded poly carbonate case
Power Requirements One 9V alkaline battery
Battery Life >8 hours (alkaline)
PG2 Handheld
Transmitter
Audio Input Level +2 dBV maximum at –10dB position
–8 dBV maximum at 0dB position
Gain Adjustment Range
10dB
RF Transmitter Output
10 mW typical
Weight
218 grams (7.7 oz.) without battery
Housing Molded PC/ABS handle and battery cup
Power Requirements One 9V size alkaline or rechargeable battery
Battery Life >8 hours (alkaline)
PG4 Receiver
Dimensions 188 mm L x 103 mm W x 40 mm D (7.4 in. x 4.0 in. x 1.5 in.)
Weight
241 grams (8.5 oz)
Output Impedance XLR connector: 200 Ω 1/4 inch connector: 1kΩ
Housing ABS
Audio Output Level Ref.
+/– 33 kHz deviation with 1
kHz tone
XLR connector (into 600 load): –19 dBV
1/4 inch connector (into 3000 load): –5 dBV
Sensitivity –105 dBm for 12 dB SINAD, typical
Image Rejection >50 dB, typical
Power Requirements 12–18 Vdc at 150 mA, supplied by external power supply

English

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Shure PG2 and is the answer not in the manual?

Shure PG2 Specifications

General IconGeneral
BrandShure
ModelPG2
CategoryReceiver
LanguageEnglish

Related product manuals