Operating the appliance en
41
Water filter
Wat er fi lter
~ Fig. '
A water filter lessens limescale deposits
and reduces impurities in the water. The
appliance also does not need to be
descaled so often. Water filters are
available from retailers or from
customer service.
If a water filter is inserted, the appliance
will show when this needs to be
changed. The ) symbol is flashing.
Inserting or replacing a water filter
A new water filter must be rinsed before
it can be used.
The appliance is switched on. The water
tank has been filled.
1. Simultaneously hold down %
and calc’nClean for at least
3 seconds.
2. Touch espresso button, and "W.
hardness" will be activated.
3. Touch % button and make the
following selection:
4. Immerse the water filter (opening
facing up) in a container filled with
water until no more air bubbles rise
to the surface.
~ Fig. '
5. Then press the water filter firmly into
the empty water tank.
6. Fill the water tank with water up to
the "max" marking.
7. Place a container with a capacity of
1.0litre under the outlet.
8. Touch espresso button to save the
setting and activate rinsing.
9. Insert water tank.
10. Touch espresso button to save the
setting and start rinsing. Water will
now flow through the filter.
11. Touch calc’nClean button to exit the
menu.
12. Then empty the container. The
appliance is ready for use again.
Removing the water filter
If the water filter has been removed and
no new one inserted, please select the
appropriate water hardness. ~ "Setting
the water hardness" on page 42
Frost protection
To prevent frost damage during
transportation and storage, the
appliance must be completely emptied
beforehand.
Info: The appliance must be ready for
use and the water tank filled.
1. Place a large container under the
outlet of the milk frother and push
the frother down.
2. Press and hold milk button for at
least 5 seconds.
The LED in the button flashes, and
the appliance now heats up.
3. As soon as steam escapes from the
milk frother, remove the water tank.
4. Allow the appliance to cool down.
Wait until ' symbol and all LEDs are
flashing.
5. Use k button to switch the
appliance off.
6. Empty the water tank and the drip
tray and thoroughly clean the
appliance.
The appliance can now be transported
or stored.
Note: The brewing unit is now secured
and cannot be removed.
with water filter
To Next Page
Loading...
Need help?
General
