30
en
The lter is no longer effective when the
Change filter! display appears, or at
the latest after 2 months. It needs to be
replaced for reasons of hygiene and so
that there is no build-up of limescale (this
could damage the appliance). Replacement
lters can be obtained from retailers or from
customer service (see “Accessories”). If no
new lter is used, turn the filter setting to
No / Old�
Note: You can use the lter indicator to
mark the month in which you inserted the
lter. You can also mark the month in which
you will need to replace the lter next (at
the latest after two months)�
Note: If the appliance has not been used
for a prolonged period (e�g� vacation) the
lter should be rinsed before the appliance
is used again� To do so, dispense a cup of
hot water and pour it away�
Menu settings
You can adapt the appliance to your indi-
vidual needs in the menu settings�
● Hold the k off / i button (13) down for at
least 3 seconds�
● Press the k off / i button (13) repeatedly
until the required menu item appears in
the display�
● Select the required setting with the upper
rotary knob (15)�
● Conrm by pressing the start button (10)�
To leave the menu without making any
changes, turn the rotary selector to Exit and
press the start button (10)�
You can set the following:
Shut off: Here you can set the time
span after which the appliance automati-
cally switches off following the last drink
preparation� A time between 15 minutes and
4 hours can be set� The default time can be
shortened to save energy�
To save power you can specify a shorter
period�
Filter: Here you can set whether a water
lter is being used. If a water lter is not
being used, turn the setting to No / Old. If a
water lter is being used, turn the setting to
Activate filter. New water lters have to be
rinsed before use (see “Water lter”).
Start Calc‘n‘Clean: The service
programmes (Calc‘n‘Clean / descaling /
cleaning) can be selected manually
here� Press the start button (10) and run
the selected programme (see “Service
Programmes”).
Temp.: The brewing temperature (high /
middle / low) can be set here�
Language: The display language can be set
here�