en Rectifying faults
68
Errors Cause Troubleshooting
No milk intake by the milk sys-
tem.
▶
Check whether the milk tube is im-
mersed in the milk.
Appliance is not dispensing
hot water.
Milk system is soiled.
▶
Clean the milk system in the dish-
washer.
→"Cleaning the milk system",
Page62
Milk system cannot be as-
sembled or disassembled.
Order of assembly is wrong.
▶
First connect the milk system and
then the milk container. When disas-
sembling, you must first remove the
milk container and then the milk sys-
tem.
Appliance is not dispensing
drinks.
Air is in the water filter. 1. Immerse the water filter in water with
the opening facing upwards until no
more air bubbles escape.
2. Reinsert the filter.
→"Insert water filter", Page57
▶
Firmly press the water filter straight
down into the tank connection.
There is dripping water on the
inner floor of the appliance.
Drip tray was removed too
soon.
▶
Wait a few seconds after the last
drink was dispensed before removing
the drip tray.
Brewing unit cannot be re-
moved.
Brewing unit is not in the re-
moval position (e.g. frost pro-
tection activated).
▶
Switch the appliance back on.
Appliance cannot be oper-
ated.
Change displays.
Appliance is in demo mode.
▶
To deactivate demo mode, press and
hold for at least 5seconds.
Grinder won't start. Appliance is too hot.
▶
Wait 1hour so the appliance can cool
down.
Notifications on the display panel
Errors Cause Troubleshooting
Display shows "Close" despite
the fact that the door is
closed.
Door is not properly closed.
▶
Press the door firmly shut.
Appliance is too hot.
▶
Wait 1hour so the appliance can cool
down.
Display shows "Please empty
drip tray and reinsert." despite
the fact that the drip tray is
empty.
Appliance is switched off and
does not detect emptying.
1. Switch the appliance on, and remove
the drip tray.
2. Re-insert the drip tray.
Drip tray is soiled.
▶
Clean the drip tray thoroughly.
To Next Page
Loading...
Need help?
General
