en Basic operation
38
2. Insert the measuring aid.
3. Insert the detergent drawer.
13.6 Adding detergent and
care product
Notes
¡ Please read the information in the
Safety →Page4 and Preventing
material damage →Page10 sec-
tions to ensure that you use the
appliance safely.
¡ Do not use the measuring aid for
liquid detergent for gel detergents,
washing powder, or if Prewash or
"Ready in" time are activated.
Requirement:Find out the optimum
dosage for detergent and care
product. →Page35
1. Pull out the detergent drawer.
2. Pour in detergent.
→"Detergent drawer", Page19
3. If required, add the care product.
4. Push in the detergent drawer.
13.7 Starting the programme
Note:If you want to change the time
until the programme ends, set the
"Ready in" time first.
▶
Press Start / Reload.
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a After the programme has ended,
the display shows: "End".
13.8 Adjusting the "Ready in"
time before the pro-
gramme starts
You can readjust the selected "Ready
in" time before the programme starts.
1. Press Start / Reload.
2. Press Finish in repeatedly until
the display indicates the desired
"Ready in" time.
3. Press Start / Reload.
13.9 Soaking laundry
Note:No additional detergent is re-
quired. The washing solution is then
used for washing.
1. Start the programme.
2. To pause the programme, after ap-
prox. 10 minutes, press
Start / Reload.
3. To resume the programme, after
the desired soaking time, press
Start / Reload.
To Next Page
Loading...
Need help?
General
