RUGGEDCOM RS900G
Installation Guide
Chapter 6
Certification
Standards Compliance 25
Certification
The RUGGEDCOM RS900G device has been thoroughly tested to guarantee its conformance with recognized
standards and has received approval from recognized regulatory agencies.
• Section 6.1, “Standards Compliance”
• Section 6.2, “Agency Approvals”
• Section 6.3, “EMI and Environmental Type Tests”
Section 6.1
Standards Compliance
The RUGGEDCOM RS900G complies with the following standards:
• FCC Compliance
This equipment has been tested and found to comply with the limits for a Class A digital device pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference on his own expense.
• Industry Canada Compliance
CAN ICES-3 (A) / NMB-3 (A)
• Other
EN 50121-4 (Wayside Rail EMI)
Section 6.2
Agency Approvals
Agency Standards Comments
CSA C22.2 No. 60950-1, UL 60950-1 ApprovedCSA
CSA C22.2 No. 142-M1987,
CSA C22.2 No. 213-M1987, UL
Std No. 916, UL Std No. 1604
Approved
Hazardous Locations
Class 1, Division 2, Groups A, B, C, and D
T6 rating at 40 °C (104 °F),
T4A rating at 85 °C (185 °F)
CE EN 60950-1, EN 61000-6-2, EN 55022
Class A, EN 60825-1, EN 50581
CE Compliance is claimed via
Declaration of Self Conformity Route
FCC FCC Part 15, Class A Approved
To Next Page
Loading...
Need help?
General
