Siemens SED2 Series User Manual

4/126
Siemens Building Technologies SED2 variable speed drives CM1U5192en
HVAC Products Introduction 01.2002
4.3.5 Power connection for drives with a built-in EMC filter ................................ 31
4.3.6 Tightening torque for connection terminals ................................................ 34
4.3.7 Cross-sections for power and motor cables ............................................... 34
4.3.8 Block diagram showing typical installation ................................................. 36
4.3.9 Direction of rotation .................................................................................... 36
4.3.10 Star or delta connection.............................................................................. 37
4.3.11 Connecting several motors......................................................................... 37
4.3.12 External motor overload protection............................................................. 37
4.4 Control terminals ........................................................................................ 38
4.5 SED2 block diagram...................................................................................39
5 Commissioning........................................................................................... 41
5.1.1 DIP switch settings ..................................................................................... 42
5.1.1.1 Setting the DIP switches on the I/O module............................................... 42
5.1.1.2 DIP switch settings on the control board .................................................... 42
5.2 Checklist prior to start................................................................................. 43
5.3 Operator panels for the SED2 .................................................................... 43
5.3.1 Description of the basic operator panel (BOP)........................................... 43
5.3.2 Description of the advanced operator panel (AOP).................................... 44
5.3.3 Exchanging the operator panels................................................................. 44
5.3.4 Buttons and their functions on the operator panel (BOP and AOP) .......... 45
5.4 Commissioning modes ............................................................................... 46
5.4.1 Overview of commissioning with the BOP or AOP..................................... 46
5.4.2 Quick commissioning.................................................................................. 46
5.4.3 Motor data for parameterization ................................................................. 48
5.4.4 Commissioning with the BOP or AOP ........................................................ 48
5.4.4.1 Country-specific default settings for operation with the BOP .....................48
5.4.4.2 Setting parameters with the BOP or AOP .................................................. 49
5.4.5 Resetting SED2 parameters to the factory settings.................................... 50
5.4.6 Basic operation with the BOP..................................................................... 50
5.4.7 10 Hz test ................................................................................................... 50
5.4.8 General operation....................................................................................... 51
6 Programming.............................................................................................. 53
6.1 Introduction to the SED2 system parameters............................................. 53
6.1.1 General notes............................................................................................. 53
6.2 Access to parameters................................................................................. 53
6.2.1 Parameter access levels (P0003)............................................................... 53
6.2.2 Parameter filter (P004) ............................................................................... 53
6.2.3 Diagram for a parameter overview ............................................................. 54
6.3 Basic functions of the SED2....................................................................... 55
6.3.1 Digital inputs............................................................................................... 55
6.3.2 Analog inputs..............................................................................................57

Siemens SED2 Series Specifications

General

Brand	Siemens
Model	SED2 Series
Category	Inverter
Language	English