IOT2000 Setting Up
Version 2.1, 08/2017
Siemens AG 2017 All rights reserved
2.2 Required Software
This chapter contains the software required for this Setting up.
Micro-SD Card Example Image
To use the full functionality of the SIMATIC IOT2000 a SD-Card Example Image
with a Yocto Linux Operating System is necessary to be installed. This Image is
provided through the Siemens Industry Online Support.
It can be downloaded here.
PuTTY
To get remote access to the SIMATIC IOT2000 software is required.
In this Getting Started “PuTTY” is used. With this software it is possible to establish
a connection to different devices for example via Serial, SSH or Telnet.
The “PuTTY” software can be downloaded here.
Win32 Disk Imager
In order to put the SD Card image to the µSD Card software is needed.
In this Setting Up the Win32 Disk Imager is used.
The “Win32 Disk Imager” can be downloaded here.
All existing data on the SD Card will be removed!
To Next Page
Loading...
Need help?
General
